Owner`s manual

97
2008 LAPALMA XL
APPLIANCES — 4
4. Pull the center cardboard tab to
automatically seal the bag and prevent
dust leakage.
5. Remove the bag from the vacuum and
discard. DO NOT reuse.
6. Check support (motor) lter.
7. Unfold the new “OX” bag and insert
into the vacuum so the center card-
board seal tab is toward bag cover. The
top arrow should point to the bag cover.
8. With a nger on each of the cardboard
tabs, slide the bag on the inlet tube.
9. Line up the mark on the bag cover with
the unlock symbol and rotate clockwise
to lock symbol.
Replacing & Cleaning the Motor Filter:
1. Inspect during each bag change. The
lter should be cleaned every fth bag
replacement or when excessively dry.
2. Remove dust bag as previously
instructed.
3. Locate the support (motor) lter in the
bottom of the bag compartment and lift
out.
4. Clean by rinsing under warm water and
let air dry if heavily soiled.Replace torn
or obstructed lters.
5. Reinstall dry motor lter before use.
Be sure lter is tucked under retaining
tabs.
6. Reinstall bag as previously instructed.
WARNING:
To reduce the risk of fire, electric
shock or injury:
Unplug and disconnect power before
servicing.

Avoid wet surfaces.
Use only manufacturer’s
recommended attachments.
DO NOT use without dustbag and/or
lters in place.
DO NOT pick up anything that is
burning or smoking, such as cigarettes,
matches, or hot ashes.
Use extra care when cleaning on stairs.
DO NOT use to pick up ammable or
combustible liquids such as gasoline
or use in areas where they may be
present.






031264e