Owner`s manual

2008 KNIGHT
95
2008 KNIGHT
APPLIANCES — 4
3. Locate the support (motor) lter in the
bottom of the bag compartment and lift
out.
4. Clean by rinsing under warm water and
let air dry if heavily soiled.Replace torn
or obstructed lters.
5. Reinstall dry motor lter before use.
Be sure lter is tucked under retaining
tabs.
6. Reinstall bag as previously instructed.
WARNING
To reduce the risk of fire, electric
shock or injury:
Unplug and disconnect power before
servicing.
Avoid wet surfaces.
Use only manufacturer’s
recommended attachments.
DO NOT use without dustbag and/or
lters in place.
DO NOT pick up anything that is
burning or smoking, such as cigarettes,
matches, or hot ashes.
Use extra care when cleaning on stairs.
DO NOT use to pick up ammable or
combustible liquids such as gasoline
or use in areas where they may be
present.







FIREPLACE ELECTRIC (OPTIONAL - 40 SKQ
ONLY)
The replace operates on 120 Volt AC
supplied by shore power and produces heat
using interior lamps. At start up the replace
may emit a slight, harmless odor caused by
the initial heating of internal parts. Follow the
recommendations listed below to reduce the risk
of re, electrical shock or injury.
Read all instructions prior to using the
replace.
The remote control supplied with the
replace will turn the unit on and off.
The main ON/OFF switch must be turned
ON before remote control will operate.
The replace is hot while in use. To
avoid burns, do not let skin touch hot
surfaces. Keep combustible materials,
such as furniture, pillows, bedding,
paper, cloth and curtains at least 3’ from
the front of the unit.
Extreme caution is necessary when the
replace is operated by or near children
and/or handicap persons and whenever
the replace is left operating unattended.
Foreign objects in any ventilation or
exhaust opening can cause electric shock,
re or damage the heater.
To prevent a possible re, do not block
air intake or exhaust in any manner.
The replace contains hot and arcing
interior parts. Do not store gasoline,
paint, or ammable liquids where the
unit will be exposed to ammable
vapors.
Do not modify this replace. Use it
only as described in this manual. Any








other use not recommended by the
manufacturer may cause re, electric
shock or injury.
Do not burn wood or other materials in
the replace.
Do not strike replace glass.
Always disconnect power before
performing replace cleaning or
maintenance.
INFORMATION
Consult OEM manual for detailed
maintenance and operating
instructions.
Operation
The following will explain the function of
each control. To access the controls, open the
upper grill by pulling the top forward and down.
To conceal the controls during operation, return
the grill to the original upright position.
Main ON/OFF Switch: The ON/OFF switch
supplies power to all replace functions (Heater/
Flame). The replace can also be turned on and
off using the remote control supplied with the
unit. The main ON/OFF switch must be turned
ON before remote control will operate.
Flame Action Control: Turn the ame
action control knob to adjust ame speed to the
desired level.
Flame Brightness Control: Turn the knob
to increase or decrease brightness of the ame
and embers.



031264e