Owner`s manual
2008 KNIGHT
93
2008 KNIGHT
APPLIANCES — 4
11. Push the On/Off button to Out (OFF)
position. The Status light should be
off.
12. If applicable, close the holding tank
drain valve.
WARNING
DO NOT use washer/dryer heat to dry
articles containing foam rubber or
similar textured, rubber-like materials.
CAUTION
DO NOT wash or dry articles that
have been previously cleaned, washed,
soaked or spotted with gasoline, dry
cleaning solvents or other flammable
or vaporous substances that could
ignite or explode. DO NOT add
gasoline, dry cleaning solvents or other
flammable or explosive substances to
the washer.
To begin a wash load:
Sort and pre-treat clothes.
Add the measured amount of detergent
suggested by the package directions
(maximum 2 tablespoons).
Load the clothes loosely into the washer.
Close the washer door.
Turn the Wash Temperature knob to the
desired temperature setting.
Choose the desired washing cycle option
using the Selector knob.
Load wash tray with detergent.
Turn the power ON.
After the cycle is complete, wait 2
minutes for the door lock to release
before attempting to open the door.
If applicable, turn the power OFF and
close the holding tank drain valve.
Washer/Dryer Maintenance
Occasionally wipe the exterior cabinet of
the washer/dryer with a damp cloth or sponge.
Wipe dry with a soft cloth. DO NOT use polish
on plastic trim. In areas of hard water, detergent
can accumulate in the drum. Obtain a packaged
water softener. Add quantity as specied by
the manufacturer directly to the drum. Run
the washer through a complete cycle using hot
water. Repeat the process if necessary. Remove
hard water deposits using only cleaners labeled
as washer safe. Wipe the inside of the washer/
dryer door with a soft cloth to remove moisture.
Periodically apply a thin coat of paste wax to the
inner door, especially to the area immediately
next to the door window, to protect the door
nish from laundry spills and discoloration.
Reduced water ow to the washer/dryer may
indicate the Hot and Cold water inlet screens
are clogged. Remove water pressure and undo
water lines at the back of the washer/dryer.
Use tweezers or pliers to remove screens from
ttings. Clean and
install screens and
water lines. Hook
to city water or
turn on the water
pump. Check for
water leaks before
using the washer/
dryer.
NOTE
Should the washer/dryer need removal
for service, care should be taken as the
washer/dryer weighs about 170 lbs.
Use proper accommodations to avoid
injury or damage to the cabinetry.
Winterizing the Washer/Dryer
Winterize Using Air Pressure:
1. Refer to Section 6 “Winterizing” and
prepare water system for air pressure.
1. Hook an airline (regulated to 45 psi or
less) to the water inlet of the
motorhome..
2. Rotate Selector knob to a wash position
with the Wash Temp setting on Warm.
Press the power button to ON. Air
pressure clears the Hot and Cold water
lines.
3. After water lines are clear, rotate Selec-
tor knob to Spin. Allow the pump to
drain the drum.
4. Set Selector knob to Reset and Timer to
zero. The door unlocks in 2 minutes or
less. Open door and pour in ¼ gallon of
non-toxic antifreeze.
5. Set selector knob to Spin. The pump
primes with antifreeze. Set selector
knob to Reset and turn the power OFF.
CAUTION
The washer/dryer may require special
winterizing instructions. Refer to
the washer/dryer OEM manual for
instructions and recommendations.
031017b