Owner`s manual

2008 KNIGHT
75
2008 KNIGHT
APPLIANCES — 4
Control Panel - Four Door
ON/OFF Button:
Turns the refrigerator ON or OFF.
Push the ON/OFF button to start the
refrigerator in Auto mode.
Push and hold the ON/OFF button for
two seconds to shut it off.


LED Display:
This screen is used for mode, temperature
and fault code display.
MODE Button:
Controls the operation mode of the
refrigerator.
Press the MODE button to select
between Automatic AU, AC or LP
operation.
SET TEMP Button:
Adjusts the temperature.
To adjust, push and hold the SET TEMP
button.
Number “9” is the coldest setting.
Manual Mode (MAN):
When one of the two manual modes is
selected:
1. AC = The refrigerator is operating on
AC electric.
2. LP = The refrigerator is operating on
LP-Gas.



Automatic Mode (AU):
This feature selects AC over LP-Gas
operation. If AC discontinues, the refrigerator
will automatically switch to LP-Gas operation.
An alarm will sound and a code will display if
the LP-Gas igniter fails to light.
Press the MODE button until AU
displays. Release the button.
Press and hold the SET TEMP button
until the desired temperature displays.
Release button.
In AUTO mode, AU/AC or AU/LP will
alternate three times when a mode has
changed.
If the LP-Gas does not ignite within 30
seconds, the control changes to a different
energy source or the gas safety valve closes and
“NO” “FL” displays. Turn the refrigerator OFF
then back ON. If the gas does not ignite after
several attempts, consult an authorized service
technician.
Tips:
Cool items rst, if possible, before
putting them into the refrigerator.




030967
Figure A
Water Valve: Located under the
refrigerator or outside behind
the refrigerator access door.
Depending on oorplan, some
models have an additional
secondary water valve located
in the water service center or
exterior compartment.
Figure B
040575
030864d
Figure C