Owner`s manual

181
2008 KNIGHT
ELECTRICAL SYSTEMS - CHASSIS — 9
RADIO: Turns on the radio. The dash radio
ON/OFF switch must be on in order for this
switch to operate.
GEN SET: The generator automatically
initiates a preheat cycle when the switch
is pressed to START. The preheat cycle is
indicated by the light on the switch ashing
rapidly. Depending on ambient temperature
when preheat cycle may last up to fteen
seconds.
To Start the Generator: Press and hold the
switch to START. The light ashes rapidly
indicating the preheat cycle. At the end of the
preheat cycle the engine will crank and start.
Release the switch after the generator has
started and is operating smoothly.
To Stop the Generator: Momentarily press
the switch to STOP. It is not necessary to hold
the switch until the generator has stopped.
STEP COVER: Extends and retracts the step
cover.
WARNING
Stepwell cover is under air pressure.
When operating the stepwell cover be
sure there are not pets, shoes or other
obstructions in the stepwell area. Do
not operate the stepwell cover while
standing in the stepwell area.
PASSENGER CONSOLE
STEP COVER: The sliding step well cover is
extended and retracted at two switch locations.
The other switch is located at the driver
console. Power comes from the house batteries
and requires the battery cut-off switch to be on.
MAP LIGHT: Turns ON and OFF map light.
The battery cut-out switch must be on for map
light to function.
PASS SHADE: Operates the power sun visor
located on passenger side.
STEP LIGHT: Operates step light.
ENTRY DOOR:
BATT CUT-OUT: Turns house battery power
on to 12 Volt domestic fuse panels.
ENTRY STEP: Provides power to operate the
entry step through magnetic switches.
PORCH LIGHT: Turns ON and OFF the
outside porch light.
CEILING LIGHT: Illuminates the front
ceiling light from the entry area.
STOR LIGHTS: Turns the bay lights ON and
OFF.
DOOR AWNING: Extends and retracts
door awning.
PATIO AWNING ON/OFF: Turns power on
and off to the patio awning.
PATIO AWNING EXT/RET: Extends and
retracts patio awning.
AIR CONDITIONER & HEATER CONTROLS
Dash AC and Heater Control: Designed to
provide heating, cooling and defrost for the pilot
and co-pilot area. The system is not capable of
heating or cooling the entire motorhome.
Blower Control Switch: Controls the four
speeds of the blower motor. This is one of the
most effective ways of controlling temperature.
The mode control switch must be in the OFF
position for the blower to activate.
Temperature Control Switch: Setting the
switch to the red zone controls an electric water
valve regulating the amount of engine coolant
passing through the heating coils in the system.
Rotating to the blue zone sets the cut-in/cut-out
temperature of the air conditioning compressor
on the engine.
Blower Speed Control
Temperature Control
Mode Control
Switch
080221