Owner`s manual
ELECTRICAL SYSTEMS - CHASSIS — 9
178
2008 KNIGHT
10. TRANS TEMP: Shows approximate
temperature of the transmission uid.
DO NOT let the transmission cooler oil
temperature exceed OEM specications.
If excess temperature is indicated, stop the
motorhome and shift to neutral. Accelerate
the engine at 1200 to 1500 RPM and
allow temperature to return to normal.
Transmission temperature can also be
monitored with the (optional) Aladdin
system.
11. AIR PRESSURE GAUGE: Uses
two needles to indicate air system
pressures. One needle indicates air
pressure of the front air tank. The other
needle indicates air pressure of the
rear air tank. The normal air system
operating pressures are 115 to 130 psi.
These air pressures are preset at the
factory. If a problem occurs with either
air system not maintaining normal
operating pressure, it is an indication
of a malfunction in the air system.
Use caution and stop the motorhome
in a safe area. Contact a qualied
technician immediately.
NOTE
Layouts may vary with difference in
models or options.
Indicator Lights
1. PARK BRAKE: Parking/emergency
brake is applied.
2. ABS: Indicates possible fault in the
ABS Brake system.
3. LEFT TURN: Audible left Turn
Indicators: Audible indicator cancels
when the brake is applied.
4. RIGHT TURN: Audible right Turn
Indicators: Audible indicator cancels
when the brake is applied.
5. CRUISE: Indicates when cruise
control is activated.
6. WARNING: Out of range condition
exists within the engine protection
circuits. Have the motorhome serviced
as soon as possible.
7. STOP ENGINE: A severe out of range
condition exists within the engine
protection circuits. Pull over and stop
as soon as possible. Shut-off engine
to avoid engine damage or related
systems.
8. ANT UP: Illuminates
when the TV antenna is raised.
Lower the antenna before moving the
motorhome.
9. LOW FUEL: Fuel level is becoming
low.
10. HEADLIGHT BEAM: Turns on
when high beams are active.
11. WAIT TO START: Monitors the air
intake heater at engine start up. Wait
for lamp to cycle off before cranking
engine.
12. CHECK TRANS: Alerts of problems
related to the Allison Transmission.
The light should momentarily
illuminate when the ignition is
switched ON. When starting, the
lamp will extinguish indicating the
circuits are working properly. If the
lamp fails to illuminate, or remains on,
the transmission needs to be checked
immediately. Contact the nearest
Allison dealer.
14
6
7
10
12
11
2
16
8
13
17
5
1 9
15
3
4
080209b
18 19