Owner`s manual

167
2008 knight
elecTrical sysTem - house — 8
6. Push bulb in and rotate to lock position.
7. Gently squeeze lens cover and insert
tabs on cover into xture.
CAUTION
Do not touch the incandescent bulbs
while it is on. Allow bulb to cool down
before replacing because a hot bulb can
cause a burn.
Interior Halogen
To Remove:
1. Grasp light xture and pull down
slightly then tilt xture to one side.
This will allow one spring clip to come
out.
CAUTION
Push spring clip inward with a finger as
clip is being eased out. If this is not done
spring clip can snap back on fingers.
2. Tilt xture to other side
and ease the other spring
clip out.
3. Unscrew the light lens
counterclockwise and
remove.
4. Carefully grasp bulb
and pull from socket.
Replace with the same
type of bulb.
5. Use a clean cloth or piece of tissue to
grasp new bulb. DO NOT touch bulb
directly as this can cause a “hot spot”
and result in immediate bulb failure.
6. Align contacts of bulb with terminals in
xture base. Insert bulb until contacts
are rmly seated.
To Reinstall:
7. Align tabs on light lens with slots in
xture base. Rotate lens clockwise
until light lens locks into place.
8. Fold up both spring clips and insert
light xture into opening. Once in
opening the spring clips will expand
and lock light xture into place.
CAUTION
DO NOT touch halogen lighting while
on. They can cause a burn. DO NOT
touch replacement bulbs. Oil in the
hands can cause a “hot-spot” to occur. If
the bulb is touched, allow it to cool and
clean the bulb with alcohol.
Fluorescent Light
Operation: Turn the xture On/Off by
pressing the power switch on the side.
To Remove a Fluorescent Tube:
Make sure light xture is Off.
Carefully squeeze both sides of lens
cover. The cover has a groove on each
side that ts into guide rail. Remove lens
cover.
Grasp the uorescent tube with both
hands and rotate so that the prongs are
facing straight up in the socket slot.
Carefully remove tube.
Replace with Philips TL 8W/33T
uorescent tube





NOTE
Replacement tube number is accurate
at the time of printing. Confirm
replacement tube number before
ordering or obtaining replacement.
To Replace a Fluorescent Tube:
Align the prongs on the uorescent tube
with socket slot.
Insert tube and using both hands rotate to
seat.
WARNING
Fluorescent bulb must be fully seated
for proper operation.
Insert one groove on the lens cover into
the guide rail.
Carefully squeeze lens cover to insert
other groove into guide rail.
CAUTION
DO NOT touch fluorescent tubes while
they are on. Make sure tubes are cool
before handling.




060200d