Owner`s manual

2008 KNIGHT
103
2008 KNIGHT
EQUIPMENT — 5
Manual Override - Bedroom
Depending on oorplan the bedroom may have
either a cable or an above oor slide-out system.
The above oor slide-out is used when the bed
moves with the slide out. If the closet moves
with the slide-out, the system is cable.
To Move the Bedroom Slide Room
(Above Floor System) Manually:
1. Turn off both the battery and house
disconnect switches.
2. The above oor slide-out motor is
located under the bed. Lift the bed and
remove the access panel.
3. Disconnect the slide-out motor
electrical plug to remove 12 Volt DC
power from the slide-out motor. The
plug can be located by following wires
that run from the motor to the plug.
4. Use a wrench to turn driveshaft and
retract room.
5. Once the slide room is manually
retracted, apply pressure to the wrench
to rmly set the room and prevent room
drift.
6. Take the motorhome to an authorized
repair center.
CAUTION
Do not continue to turn the motor after
the room is fully extended or retracted.
Damage to the slide mechanism can
occur.
To Move the Bedroom Slide Room
(Cable System) Manually:
1. Turn off both the battery and house
disconnect switches.
2. Locate the bedroom slide-out motor.
The motor is located near the ceiling
of the slide-out. Remove the fascia,
valance, or both.
3. Disconnect the slide-out motor
electrical plug to remove 12 Volt DC
power from the slide-out motor. The
plug can be located by following wires
that run from the motor to the plug.
4. Attach the exible shaft to the tting on
the end of the slide-out motor.
5. Attach a socket and ratchet or drill
to the other end of the exible shaft.
reverse the direction. Over-torquing
can cause severe damage.
6. Turn in proper direction to move the
room. If the cables tighten and the
motor is difcult to turn, reverse the
direction. Over-torquing can cause
severe damage.
7. Take motorhome to an authorized repair
center
AWNINGS
Slide-out Cover
The slide-out cover automatically reacts to
slide-out direction. A xed edge of the slide-out
cover is installed into an awning rail, mounted
just above the slide-out. A spring-loaded roller
with special brackets mounts to the slide-out. In
a hard rain the cover helps prevent water from
penetrating the seal of the slide-out. The
slide-out cover will automatically reach full
extension when the slide-out room is fully
extended.
The slide-out cover automatically rolls up into
the travel position when the slide-out room is
completely retracted.
030750c
031277d
031236
Slide-out cover
Slide-out awning
Slide-out