User guide

Assembling TSX Momentum Components
870 USE 101 00 V.2.2
65
Mounting the Assembled Adapters on the I/O Base,
Continued
Procedure:
Mounting the
Assembled
Adapters on an
I/O Base
Follow the steps in the table below to mount the assembly on an I/O base.
Continued on next page
Step Action
1 Make sure that the I/O base is not under power when you assemble the module.
2 Align the four plastic snap extensions (on the front and sides of the Option
Adapter) with the slots on the I/O base.
The 12-pin ATI connectors will automatically line up when the units are in this
position. The devices should be oriented such that their communication ports are
facing out on the back side of the assembly.