User guide

Using Peer Cop with Concept
870 USE 101 00 V.2.2
291
Accessing the Peer Cop Dialog Box
Introduction
This section describes how to access the Peer Cop dialog box in Concept 2.1.
Accessing the
Screen
Follow the steps below to access the Peer Cop from the PLC Configuration Screen.
Continued on next page
Step Action
1 Check the status of Peer Cop.
If Peer Cop is enabled, jump to step 4.
If Peer Cop is disabled, continue with step 2.
Example:
The Peer Cop status is reported in the Configuration Extensions
section of the PLC Configuration Screen. Here Peer Cop is disabled:
2 Double-click on the Peer Cop field.
Result:
The Configuration Extension dialog box appears.