User guide

48248-EN/2
The Momentum specialty module I/O bases provide support for unique applications
that broaden the range of the Momentum offering. The specialty modules are :
b a 2-channel, High-Speed Counter Module Base - 170 AEC 920 00.
b a 120 VAC, 6-point Input/3-point Output Module Base with a Modbus
Communication Port - 170 ADM 540 80.
b a Base Module that provides an interface between Momentum and the SERIPLEX
Component Network - 170 ANM 050 10.
The 170 AEC 920 00 High-Speed Counter Module Base features 2 independent
counters, along with 6 discrete inputs and 4 discrete outputs.This base can connect
directly to either 5 VDC differential or 24 VDC single-ended encoders. The base
supports two operating modes: incremental (up counter, down counter, and
quadrature); and absolute (SSI up/down counter). The high-speed counter module
can be connected directly to many standard communication networks, for
communicating with programmable controllers, industrial computers, and other
controllers, by installing one of the snap-on Momentum Comm Adapters onto the
base.
The 170 ADM 540 80 input/output module base has 6 discrete inputs and 3 discrete
outputs for direct connection to 2- and 3-wire sensors and actuators, plus a Modbus
Communication Port for connection to serial devices. This module can also be used
as the I/O base for a programmable controller, in either a standalone or distributed
I/O configuration, by installing one of the snap-on Momentum M1 Processor
Adapters.
The 170 ANM 050 10 SERIPLEX interface for Momentum controllers allows the
exchange of I/O data over the SERIPLEX Component Network. SERIPLEX, from
Square D, is a device-level control network with over 3 million installed I/O points
worldwide. The interface acts as a slave to its host controller, and as a master for
the SERIPLEX bus. The SERIPLEX base unit may have a Momentum processor
adapter or communications adapter mounted on it, thus supporting three powerful
control architectures :
b Standalone Momentum controllers with SERIPLEX I/O devices.
b Networked, distributed Momentum controllers, some or all of which may connect
to SERIPLEX I/O devices.
b A centralized control processor connecting to SERIPLEX bus devices and/or other
types of I/O devices through a higher-level control network, such as Ethernet,
Modbus Plus, DeviceNet, Interbus, or Profibu.
A specialty module I/O bases consists of the following components :
1 Internal interface connectorfor the communication module.
2 Locking and earth contact for the adapter.
3 LED status display.
4 Two connectors for the removable terminal blocks.
5 Earthing screw.
6 Grounding busbar mounting slot.
7 Mounting holes for a panel mount.
8 Protective cover for fuses (170 ADM 54080) or connector for the removable
terminal block.
Presentation
High-Speed Counter
Input-Output Module with Modbus Comm Port
SERIPLEX Module
Description
Momentum automation platform 0
Momentum specialty module I/O bases
Presentation,
description
Characteristics :
pages 48248/3 and 48248/4
References :
page 48248/4
Connections :
page 48248/5