Specifications

26
Initialize: loads factory default values to PC Setup screen and to CommandCall control unit memory
Save ... : writes PC Setup screen actual values into file stored in your PC (system will request user to
specify file name and location). By this means it is possible to have stored several standard
configurations of parameters and SMS texts or archives of specific installations / customer
settings stored during unit installation.
Load ...: reads parameters setting from file stored in your PC onto CommandCall PC Setup screen
(system will request user to specify file name and location). Just after using „Apply“ function
loaded data from the file are written into CommandCall control unit memory.
Exit: quits the session of CommandCall PC Setup
CommandCall PC Setup will read only firmware version from control unit after the start and will
display it in upper left corner of the screen, in section Unit information. To display actual
parameter values press „Request“ on bottom task bar of the CommandCall PC Setup screen.
To write actual parameters setting from the PC Setup screen into CommandCall control unit
memory please press „Apply“ on bottom task bar of the CommandCall PC Setup screen.
The communication of your PC with CommandCall control unit is automatically
terminated after 5 minutes of „idle“ period. To restore normal activity of the unit exit PC
Setup and start it again, please. In such case when system displays error message
„Communication failed“ (during „Request“ or „Apply“ function) it is recommended to
store unsaved parameter settings into temporary file on your PC by using
„Save“ command, then you can restart PC Setup and you can retrieve those parameters
setting onto CommandCall PC Setup screen by using „Load“ function to restore data
from the temporary file and to continue your job.
Initialisation screen of PC Setup requests to enter COM port number even when CommandCall control unit
is connected over the USB port of the computer !
7. CommandCall USB Programming Adapter
CommandCall control unit programming is possible with using USB Programming Adapter. USB
Programming Adapter is interface device for connecting CommandCall control unit with PC and to use
CommandCall PC Setup. In the case your computer does not recognize inserted USB Programming
Adapter it is necessary to install USB to COM port converter utility (USB to UART conversion).
Close all applications before inserting USB Programming Adapter into USB port of your
PC !
LED built in USB Programming Adapter flashes only during active data transfer between
CommandCall control unit and PC Setup programme.
CommandCall
USB Programming Adapter is optional accessory (it is not included in CommandCall kit).