Specifications

20
6. CommandCall PC Setup
Before using CommandCall PC Setup it is necessary to install CommandCall PC Setup programme on
your PC. Installation procedure of CommandCall PC Setup programme is described in details in the
Chapter 12.
Before programming CommandCall the control unit must be switched OFF from the power and
backup battery must by cut OFF too (see 3.4.). When backup battery is switched OFF red LED
will switch OFF. During the communication of CommandCall with PC Setup programme
CommandCall is powered from USB port of your PC and red LED quickly flashes. During active
PC Setup session CommandCall is in service mode and GSM module is not active.
It is recommended to take OFF SIM card from the CommandCall control unit before starting its
programming by CommandCall PC Setup.
Before installing new SIM card into CommandCall control unit set up SIM card PIN to 0000 (default
SIM PIN set during HW production). In such case new CommandCall unit can be installed to the
vehicle even without using PC Setup.
If you plan to use another SIM PIN code you must write this PIN code into CommandCall by PC Setup !
By typing wrong PIN code of SIM card in the CommandCall PC Setup programme the
SIM card will be blocked (system tries to register to GSM network repeatedly and will
use all 3 allowed attempts to give correct PIN code of the SIM card).
It is possible to use SIM card with disabled function of validating PIN code. In such case SIM PIN code
stored in CommandCall control unit is ignored.
During CommandCall PC Setup installation new icon is created on „Desktop“ of your computer.
By left mouse button double click on this icon you can start CommandCall PC Setup programme.
CommandCall PC Setup is possible to start also from „START“ menu of your computer through
„PROGRAMMS“ submenu. CommandCall PC Setup is stored in „MOLPIR“ folder.
Close all applications before using USB Programming Adapter, then insert CommandCall
Programming Adapter into any free USB port of your PC and then insert 10 PIN connector into
CommandCall control unit.
When CommandCall PC Setup starts it should recognize COM port automaticaly, if there is an error
please select assigned COM port from the list and then select the language from the list (14 languages are
available) and within 30 seconds press “OK” to enter the programme.
Note: Manual identification of COM port is described in Chapters 8 and 13 of this manual.