Specifications

17
keeps system operation for limitted period of time after disconnecting vehicle battery to enable
sending emergency reports to the user.
After disconnecting power supply it is possible to disconnect backup battery immediately, press and keep
pressed ON/OFF push button for 20 seconds. LED will flash twice after elapsing 20 second time and then
release push button.
5.3. Indication of reaching limit temperatures
CommandCall enables to measure actual in car temperature and to compare it with 3 stored temperature
limit values UST, UST1 and UST2.
UST is processed in the system as independent limit temperature value. System monitors actual
temperature, reaching limit value UST and the direction of temperature change. If the limit value UST is
exceeded and the temperature is stable „behind“ the limit value for time period longer then parameter value
TS, system will send to maximum 3 phone numbers listed in tripple checkbox No. 34 or 35 respective SMS
report No. 34 or 35 - depending on situation explained in the chart:
The values UST1 and UST2 are in the system handled as temperature interval. System monitors actual
temperature, entering and leaving interval limits and the direction of temperature changes (temperature
increase or decrease). If the limit value is exceeded and the temperature is stable „behind“ the limit value
for time period longer than parameter value TS1 system will send to to maximum 3 phone numbers listed in
tripple checkboxes No. 36 to 39 respective SMS report No. 36, 37, 38 or 39 - depending on situation
explained in the chart: