User Guide

ManualsBrandsmolift ManualsSpreader Barmolift Mover 180 4-Point Spreader Bar

Molift Mover 180, Quick guide | QG08101 Rev. B | www.etac.com

Quick guide (EN)

QG08101 Rev B 2022.10.17

Molift Mover 180

Important

Read user manual before use! This Quick guide does not replace user manual. It is important to fully understand the

content of the user manual before attempting to use the equipment.

Go to www.etac.com for latest version of the user manual.

Never exceed the Safe Working Load (SWL) of 180 kg (397 lbs).

If maximum load (SWL) differs between hoist and body support unit, then the lowest maximum load shall always be

used.

Molift hoists shall only be used to lift persons. Never use the hoist to lift or move objects of any kind.

Lifting arm

Push

handles

Motor / actuator

Emergency

stop

Hexagon

socket screw

Legs

Electric emergency

lowering

Chassis

Sling bar

Battery

Lifting column

Manual emergency lowering

Hand

control

Wheel / castor (Rear with brake)

Hexagon

socket screw

Service

indicator Mode

No light

Power saving

(Stand by)

Green Ready for use

Yellow Order service

Red Perform service

Red + sound

Perform service

immediately

Battery

indicator Mode

Light Low battery

No light Charged battery

Summary of content (2 pages)

PAGE 1
Molift Mover 180, Quick guide | QG08101 Rev. B | www.etac.com Molift Mover 180 Quick guide (EN) QG08101 Rev B 2022.10.
PAGE 2
Molift Mover 180, Quick guide | QG08101 Rev. B | www.etac.com Handcontrol and opreation Sling bar placement and sling attachment ① ② ③ ④ Never lift the user higher than necessary to carry out a lift. Remember that wheels on a mobile hoist must NOT be locked. The hoist shall not be used to lift or move users on sloping surfaces. User positions for transfer and lowering Do not push or pull the user, lifting arm or actuator. This may cause stability problems and hoist may tip over.