Manualshelf

Datasheet

ManualsBrandsMolex ManualsConnector ToolsHandtool for Picoflex Connectors, 4-26 Circuit
123456
Manual Hand Tool for Picoflex® PF-50 Connectors
Doc No: ATS-690081090 Release Date: 06-28-05 UNCONTROLLED COPY Page 5 of 6
Revision: F Revision Date: 07-17-12
NUMBERED
ADJUSTMENT
WHEEL
Figure 5
TURN CLOCKWISE (CW) OR
COUNTER CLOCKWISE (CCW)
TO ADJUST THE PRE-LOAD
TURN WITH A SMALL
SCREW DRIVER
REMOVE THE 2MM LOCKING SCREW
2. Using the same screw driver turn the adjustment wheel to the next highest number.
Note: The odd numbers are in clockwise (CW) direction and the even numbers are counter clockwise (CCW).
3. Example: If the preload is set at number 5, then to increase the preload, turn the adjustment wheel until the 6
th
position is located over the 2mm locking screw tapped hole. If it is necessary to move to the 7
th
position, then
the adjustment wheel should be turned clockwise (CW) until the 7
th
position is over the 2mm locking screw
tapped hole.
4. Replace the 2mm locking screw, aligning the nearest notch in the setting wheel to locking screw.
5. Check the termination specifications after the tool handle preload force is adjusted. Repeat these steps until
the desired result is obtained.
Warranty
This tool is for electrical termination purposes only. All tools are warranted to be free of manufacturing defects for
a period of 30 days. Should such a defect occur, we will repair or exchange the tool free of charge. This repair or
exchange will not be applicable to altered, misused, or damaged tools. This tool is designed for hand use only.
Any clamping, fixturing, or use of handle extensions voids this warranty.
CAUTION: Molex crimp specifications are valid only when used with Molex terminals and tooling.
CAUTIONS:
1. Manually powered hand tools are intended for low volume or field repair. This tool is NOT intended for
production use. Repetitive use of this tool should be avoided.
2. Insulated rubber handles are not protection against electrical shock. NEVER perform crimps on active
electrical circuits.
3. Wear eye protection at all times.
4. Use only the Molex terminals specified for crimping with this tool.