Datasheet

Hand Crimp Tool Quick Disconnect, Female Crimp Terminals
Doc No: ATS-638279300 Release Date: 12-02-15 UNCONTROLLED COPY Page 3 of 7
Revision: A Revision Date: 12-02-15
TERMINAL
WIRE AGAINST
THE WIRE STOP
WIRE
LOCATOR
Figure 3
PRE-STRIPPED
WIRE
TERMINAL
RELEASE
THE
LEVER
OPERATION
Open the tool by squeezing the handles together. At
the end of the closing stroke, the ratchet mechanism
will release the handles and the hand tool will spring
open. See Figure 1.
Crimping Terminals
1. Select the desired terminal listed in the
preceding charts.
2. Push the wire stop lever on the side of the hand
tool to raise the wire stop up before inserting the
terminal in the hand tool. See Figure 2.
3. With the wire stop lever pushed in, load the
terminal into the proper nest opening marked with the wire gauge on the hand tool. See Figure 2.
4. Next release the wire stop lever, allowing the wire stop to return to the crimping position.
5. Insert the properly stripped wire through the terminal and against the wire stop. See Figure 3.
6. Crimp the terminal by squeezing the tool handles until the ratchet mechanism cycle has been completed.
Release the handles to open the jaws. See Figure 4.
Note: The tamper proof ratchet action will not release the tool until it has been
fully closed.
7. Push the wire stop lever in to raise the wire stop up and remove the crimped
terminal from the locator by lifting up and then pulling the wire out.
8. Visually inspect the crimped terminal for proper crimp location.
Locator Replacement
See the parts list on the last page of this document for the proper locator order
number. Follow the steps below to replace the locator.
1. Open the crimp hand tool and turn the tool upside down on the back side.
2. Remove the tightening lock nut.
HANDLES
OPEN
Figure 1
INSERT
TEMINAL
PUSH
LEVER TO
RAISE WIRE
STOP
Figure 2
SQUEEZE
HANDLES
TOGETHER
LEVER
UP
Figure 4