Datasheet

Extractor Tool for Mega-Fit Series Terminals

Doc No: ATS-638240800 Release Date: 09-19-13 UNCONTROLLED COPY Page 1 of 2

Revision: A Revision Date: 09-19-13

TERMINAL

EXTRACTOR

TOOL

PULL WIRE AND

TERMINAL

SLOTS FOR

EXTRACTOR TOOL

HOUSING

Figure 1

Extractor Tool

Application Tooling

Specification Sheet

Order No. 63824-0800

FEATURES





 This Extractor Tool is for the removal of Mega-Fit Crimped Terminals Series from their housings

SCOPE

Products: Mega-Fit Female Crimp Terminals, 12-16 AWG.

Terminal Series No

Terminal Order No.

Housing Series

76823

0321

76823

0322

170001 and 171692

172063

0311

172063

0312

OPERATION:

1. Insert the extractor tool into the housing as shown in Figure 1.

2. Use the slots located on the inside of the housing to guide the extraction tool blades into the housing until

contact is made with terminal.

3. Continue to insert the tool always checking to see that the blades of extraction tool are on the outside of the

contact as shown in Figure 2.

PAGE 1
Extractor Tool for Mega-Fit Series Terminals Extractor Tool Application Tooling Specification Sheet Order No. 63824-0800 FEATURES This Extractor Tool is for the removal of Mega-Fit Crimped Terminals Series from their housings SCOPE Products: Mega-Fit Female Crimp Terminals, 12-16 AWG. Terminal Series No. Terminal Order No. Housing Series No. 76823 76823-0321 76823-0322 170001 and 171692 172063 172063-0311 172063-0312 OPERATION: 1. Insert the extractor tool into the housing as shown in Figure 1.
PAGE 2
Extractor Tool for Mega-Fit Series Terminals LOCKING TABS DEPRESSED EXTRACTOR TOOL FINGERS MUST BE ON THE OUTSIDE OF THE TERMINAL CONTACTS TERMINAL Figure 2 (HOUSING REMOVED) EXTRACTOR TOOL 4. Continue to insert extraction tool into housing until the locking tangs have snapped out of their locked position. If the terminal locking tabs are still not totally depressed, hold on tight to the wire and push it towards the extractor tool, this will completely depress the locking tabs. See Figure 2. 5.