Datasheet

Hand Crimp Tool For Micro-Fit 3.0™ Crimp Terminals
Doc No: ATS-638190000 Release Date: 10-11-07
UNCONTROLLED COPY Page 6 of 8
Revision: A Revision Date: 10-11-07
Figure 10
SQUEEZE
THE LINK IN
THE HANDLE
HOLD THE HAND
TOOL IN POSITION
SETTING
WHEEL
RATCHET
RELEASE LEVER
How to Adjust Tool Preload (See Figure 10)
This hand tool is factory preset to 25-45 LBS. preload. It may be necessary over the life of the tool to adjust tool
handle preload force. Listed below are the steps required to adjust the crimping force of the hand tool to obtain
proper crimp conditions:
1. Hold the hand tool in the palm of
your hand as shown in Figure 10.
Using the index finger squeeze the
link towards the top of the hand
tool frame. This will release the
preload adjustment wheel.
2. Rotate the setting wheel counter-
clockwise (CCW) to increase
handle force. The numbers will
display higher. To decrease
handle force rotate the setting
wheel clockwise (CW).
3. Release the link to lock the setting
wheel in place.
4. Check the crimp specifications or
conduct a pull test after tool handle preload force is adjusted.
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long life tested. All tools are warranted to be free of manufacturing defects for a period of 30
days. Should such a defect occur, we will repair or exchange the tool free of charge. This repair or exchange will
not be applicable to altered, misused, or damaged tools. This tool is designed for hand use only. Any clamping,
fixturing, or use of handle extensions voids this warranty.
CAUTION: Molex crimp specifications are valid only when used with Molex terminals and tooling.
CAUTIONS:
1. Manually powered hand tools are intended for low volume or field repair. This tool is NOT intended for
production use. Repetitive use of this tool should be avoided.
2. Insulated rubber handles are not protection against electrical shock.
3. Wear eye protection at all times.
4. Use only the Molex terminals specified for crimping with this tool.