Datasheet
Manual Wire Stripper Tool
Doc No: ATS-638170000 Release Date: 10-29-10 UNCONTROLLED COPY Page 3 of 3
Revision: A Revision Date: 10-29-10
Follow the steps below for changing the stripping cassette.
1. Adjust the stripper blade to
the + position.
2. Hold the tool shut and slide
the wire stop forward.
3. The cassette is removed
from the side of the tool.
4. Align the hole of the new
cassette with the pivot pin in
the tool.
5. Push the new cassette fully
into the tool.
Maintenance
It is recommended that each operator of the tool be made aware of, and responsible for, the following maintenance
steps:
1. Remove dust, moisture, and other debris with a clean brush, or soft, lint
free cloth.
2. Do not use any abrasive materials that could damage the tool.
3. Lubricate every 10, 0000 cycles.
4. Make sure the blade is cleaned of debris.
5. When the tool is not in use, store it in a clean, dry area.
Warranty
This tool is for stripping and cutting electrical cable only. All tools are warranted to be free of manufacturing
defects for a period of 30 days. Should such a defect occur, the tool will be exchanged free of charge. This
exchange will not be applicable to altered, misused, or damaged tools. This tool is designed for hand use only.
Any alteration to the tool voids this warranty.
ORDERING INFORMATION
Order No
Description
Notes
63817-0000
Complete Manual Wire Stripping Tool with Straight Blade
♦
63817-0070
Straight Blade Replacement Cassette 8-34 AWG
Used with PVC Insulation
63817-0071
“V” Blade Replacement Cassette 12-28 AWG
Used with PTFE Insulation
63817-0072
Straight Blade Replacement Cassette 5-10 AWG
Used with PVC Insulation
♦This tool (63817-0000) comes complete with the straight blade.
To use the “V” blade, order the complete tool with straight blade (63817-0000)
plus the “V” blade (63817-0071) and replace the stripping cassette.
Visit our Web site at http://www.molex.com