Datasheet

Extractor Tool for Crimp Terminals
Doc No: ATS-638132700 Release Date: 11-07-07 UNCONTROLLED COPY Page 7 of 7
Revision M Revision Date: 09-01-09
Figure
17
HOUSING
INSERT EXTRACTOR
TOOL INTO SLOT
TERMINAL
WIRE
EXTRACTOR
TOOL
TERMINAL
LOCKING
TAB PUSHED UP
TERMINAL
Figure 18
For 94518 Terminal Series:
1. Push the wire of the crimped terminal to be removed forward into the connector housing before using the
Extractor Tool.
2. Insert the Extractor Tool into the slot below the terminal, seated in the connector housing and slide it
forward until it stops. See Figure 17.
3. Pull the wire and terminal back through the Connector slot in the arrow direction as shown. See Figure
18.
CAUTION: Molex specifications are valid only when used with Molex terminals, applicators and tooling.
Molex does not offer repair parts for Extraction Tools due to the inexpensive nature of the tool.
Americas Headquarters
Lisle, Illinois 60532 U.S.A.
1-800-78MOLEX
[e-mail]
Far East North Headquarters
Yamato, Kanagawa, Japan
81-462-65-2324
[e-mail]
Far East South Headquarters
Jurong, Singapore
65-6-268-6868
[e-mail]
European Headquarters
Munich, Germany
49-89-413092-0
[e-mail]
Corporate Headquarters
2222 Wellington Ct.
Lisle, IL 60532 U.S.A.
630-969-4550
Fax: [phone]
Visit our Web site at http://www.molex.com