Datasheet

Extractor Tool for Crimp Terminals
Doc No: ATS-638132700 Release Date: 11-07-07 UNCONTROLLED COPY Page 5 of 7
Revision M Revision Date: 09-01-09
LOCKING TAB
OF HOUSING
WIRE
Figure 1
2
EXTRACTOR TOOL
AND WIRE PULLED
OUT TOGETHER
LOCKING TAB
PUSHED UP
TERMINAL
EXTRACTOR TOOL
TERMINAL
EXTRACTOR
TOOL
PULL OUT WIRE
WITH TERMINAL
HOUSING LOCK
LIFT
HOUSING LOCK
EXTRACTOR
TOOL
TERMINAL
WIRE
Figure 10
Figure 11
TERMINAL
PUSHED IN
LOCKING TANG
PUSHED DOWN
EXTRACTOR
TOOL
ON AN ANGLE
HOUSING
50148
-
8*00 TERMINAL
FIGURE
9
5. Insert the tip of the Extractor
Tool on an angle into the
connector housing. See Figure
9.
6. While pushing the extraction tool
against the terminal locking tang,
bend the locking tang down and
away from the terminal. At the
same time a second person pulls
on the crimped wire to release
the terminal from the housing.
For 501930 Terminal Series:
1. Line up the terminal to be removed in the
connector assembly with the tip of the Extractor
Tool. Insert and slide the Extractor Tool into the
slot on the side of the connector housing as
shown. Positioning it under the housing lock as
shown in Figure 10.
2. Slide the Extractor Tool in the direction shown
lifting up the housing lock. While lifting the
housing lock, push the terminal back through the
connector slot and pull the terminated wire out in
the arrow direction. See Figure 11.
For 50539 Terminal Series:
1. Push the terminal forward in the arrow direction before using the Extractor Tool.
2. Insert the Extractor Tool into the slot above the terminal in the connector housing as shown in Figure 12.
3. Gently push the extractor tool till it stops. The housing locking tab should be bent up.
4. Pull the terminal and the terminated wire back through the Connector slot along with the extractor tool in
the arrow direction as shown.