Datasheet

Extractor Tool for Crimp Terminals

Doc No: ATS-638132700 Release Date: 11-07-07 UNCONTROLLED COPY Page 2 of 7

Revision M Revision Date: 09-01-09

OPERATION:

CAUTION: This extractor tool should be used to extract the terminal only. Using it for unintended purposes

may cause injury or damage to parts. Be careful not to deform the end of the terminal. Avoid lifting the housing

lock too high.

For 35053 48105, 78172, 87421, and 502057

Terminal Series:

1. Push the terminal forward into the housing before using

the Extractor Tool.

2. Insert the Extractor Tool into the slot on the bottom of the

connector housing as shown in Figure 6. Make sure the

straight edge of the extractor tool is up against the

housing lock.

3. Gently lift up on the housing tab and push the terminal

back through the connector slot and pull the terminated

wire out in the arrow direction. See Figure 1.

For 35465 Terminal Series:

1. Push the terminal and the wire forward in the arrow direction

before using this Tool.

2. Insert the Tool into the slot above the locking tang of the terminal.

3. Push the tool down until the locking tang is even with the rest of

the terminal. This will free the terminal from the housing.

4. Pull the crimp wire back through the connector slot in the arrow

direction as shown in Figure 2.

Figure 1

EXTRACTO

TOOL

WIRE

HOUSING

LOCK

TERMINAL LOCK

Figure

EXTRACTOR

TOOL

HOUSING

TERMINAL

LOCKING

TANG

PUSHED UP

PUSH IN TERMINAL

AND WIRE