Datasheet

Hand Crimp Tool for SL Crimp Terminals
Doc No. ATS-638118700 Release Date: 07-30-07 UNCONTROLLED COPY Page 7 of 8
Revision: E Revision Date: 11-09-17
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long life tested. All tools are warranted to be free of manufacturing defects for a period of 30 days.
Should such a defect occur, Molex will repair or exchange the tool free of charge. This repair or exchange will not
be applicable to altered, misused or damaged tools. This tool is designed for hand use only. Any clamping,
fixturing or use of handle extensions voids this warranty.
CAUTION: Molex crimp specifications are valid only when used with Molex terminals and tooling.
CAUTIONS:
1. Manually powered hand tools are intended for low-volume use or field repair. This tool is NOT intended for
production use. Repetitive use of this tool should be avoided.
2. Insulated rubber handles are not protection against electrical shock.
3. Wear eye protection at all times.
4. Use only the Molex terminals specified for crimping with this tool.
Certification
Molex does not certify or re-certify hand tools but rather supplies the following guidelines for customers to re-
certify hand tools:
 This tool is qualified to pull force only. To re-certify, crimp a terminal to a wire that has been stripped
12.7mm (1/2”) long so that there is no crimping of the insulation. Pull the terminal and wire at a rate no faster
than 25mm (1.00”) per minute. See the Molex website for the Quality Crimp Handbook for more information
on pull testing.
 If the tool does not meet minimum pull force values, handle preload should be increased, and the pull test
should be rerun (see How to Adjust Preload).
 When the hand tool is no longer capable of achieving minimum pull force, it should be taken out of service
and replaced.