Datasheet

Hand Crimp Tool for SL Crimp Terminals
Doc No. ATS-638118700 Release Date: 07-30-07 UNCONTROLLED COPY Page 5 of 8
Revision: E Revision Date: 11-09-17
Figure 8
PUSH ON
HANDLE
JAWS OPEN
PULL OPEN
TOOLING
TOOLING
M3 BHCS
3. Lift and pull away from the hand tool. The top
locator hooks should slip out of the top slots
easily. See Figure 7A.
4. To reinstall the new locator, make sure the
hand tool is in the open position.
5. Press the red insert down as far as it will go as
shown in Figure 7B.
6. Holding onto the lower part of the locator with
your thumb and index finger, insert the
locator’s top hooks (2) into the hand tool top
slots.
7. Rotate the locator down, and press the lower
tabs into the two bottom slots of the hand tool.
To secure the locator into place, the lower tabs
must snap into place on the hand tool frame.
Right or Left Hand Operation
This hand tool has an added feature that can be
converted from a right handed application to a left handed application. It is necessary to reverse the tooling if using
the left handed application along with the locator. Follow the steps below:
1. The locator must be removed before reversing the
tooling.
2. Remove the M3 BHCS that is holding the upper
tooling.
3. Flip the upper tooling to the opposite side, and
replace the M3 BHCS. Make sure the small
markings on the front and back of the hand tool
frame match up and are on the outside of the hand
tool frame. See Figures 8 and 9.
4. Do the same thing with the lower tooling, and
tighten the M3 screws. Be sure the small markings
line up.
5. Reinstall the locator by following the instructions in
the locator replacement section.
SQUEEZE
HERE
LOCATOR
Figure 7A
SQUEEZE
HERE
TOP HOOKS
TOP SLOTS OF
HAND TOOL
LOWER TABS
MAKE SURE
CENTER OF LOCATOR
IS IN THE
DOWN POSITION
Figure 7B
MATCH
UP MARKS
FRONT
BACK
Figure 9