Datasheet

Tool Kit for Sabre™ Flat Blade Crimp Terminal
Doc No: ATS-6381173HM Release Date: 02-12-07 UNCONTROLLED COPY Page 2 of 9
Revision: C Revision Date: 09-09-10
WIRES
SIDE BY SIDE
NO
YES
WIRES
VERTICALLY
STACKED
WIRES
VERTICALLY
STACKED
TERMINAL
WIRES
SIDE BY SIDE
TERMINAL
▲Insulation Crimp Note:
Due to the terminal’s insulation grip design
and/or insulation diameter range, this tool
uses “overlap” form geometry in the
insulation punch. This produces an overlap
insulation crimp (A620 – compliant). While
the insulation punch profile may appear
“lopsided”, this is a normal condition for this
tool. See figure to the right. (Some tools with
multiple crimp pockets may not have the
“overlap” profile on all pockets).
Wire Feeding Orientation
This Hand Tool was developed for (2) 18 AWG wires in a vertically stacked orientation. See the following
illustrations below.
CONDITIONS:
After crimping, the conductor profiles should measure the following (See notes below).
OVERLAP
INSULATION
CRIMP
OVERLAP FORM GEOMETRY
ANVIL
PUNCH
WIRE