Datasheet

PRODUCT SPECIFICATION
REVISION:
ECR/ECN INFORMATION:
TITLE:
2IN1(4G/GPS&BD) EXTERNAL ANTENNA
PRODUCT SPECIFICATION
SHEET No.
A
EC No:
610960
6 of 7
DATE:
2019/01/30
DOCUMENT NUMBER:
CREATED / REVISED BY:
CHECKED BY:
APPROVED BY:
PS-2112973000
Kang Cheng 2019/01/24
Cooper Zhou 2019/01/24
Stary Song 2019/01/24
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A4](V.1).DOC
Pull Test
1. The antenna is fixed on the fixture, the cable pulled to the axial
direction. Pull force≥15N
Electrostatic ESD
1. Antenna in working condition, ± 8KV Air discharge test: Plastic
shell surface height of 15 mm at any position, the discharge
interval is greater than 5s, the number of positive and negative 3
times; ± 6KV Contact Experiment: Metal connector shell contact
discharge, discharge interval greater than 5s, the number of
positive and negative 3 times
2. Parts should meet RF spec before and after test.
3. No cosmetic problem (No bubble issue、No plating peeling off
issue、 No mechanical damage.)
Connector Salt Mist Test
1. Concentration of salt solution: 5%±1%, Temperature range:
35±2°C, PH value range: 6.5-7.2, Settling amount of salt fog: 1-
2ml/(80cm2•h), Test time: 48h
2. Parts should meet RF spec before and after test.
3. No visible corrosion. Discoloration is acceptable.
Temperature Cycle
1. In an environment of 20 ° C, the temperature reached -40 ° C
within 60 min, and the test device was stored for 90 min.
2. The temperature reached 20°C in 60 minutes.
3. In an environment of 20 ° C, the temperature reached 85 ° C
within 90 min, and the test device was stored for 110 min.
4. The temperature reached 20°C in 70 minutes.
5. The cycle is repeated until a total of 40 cycles have been
completed. Cycle time: 8 hours
6. Parts should meet RF spec before and after test.
7. No visible corrosion. Discoloration is acceptable.
Temperature Shock
1. 1.The device under test at -30 ℃⇔70 ℃ by 100 cycles, Dwell of
2. 30 mins, transition time between Dwell 10 secs (45 mins /
cycle)
3. Parts should meet RF spec before and after test.
4. No cosmetic problem（No soldering problem；No adhesion
problem of glue）
Constant Damp Heat
1. Test temperature: 40±2°C, test humidity: 95%, storage time: 504h
2. Parts should meet RF spec before and after test.
3. No cosmetic problem（No soldering problem；No adhesion
problem of glue）
Mechanical Shock
1. Impact acceleration: a=500±10% m/S2,
2. Enter the time: t = 6 m/s, each space axis (six axis) each test 10
times.。
3. Parts should meet RF spec before and after test.
4. No cosmetic problem（No soldering problem；No adhesion
problem of glue）