PRODUCT SPECIFICATION TITLE ISM 433MHz Flex Antenna TABLE OF CONTENTS 1.0 SCOPE 2.0 PRODUCT DESCRIPTION 3.0 APPLICABLE DOCUMENTS AND SPECIFICATIONS 4.0 RATINGS 5.0 PERFORMANCE 6.0 TEST GROUPINGS 7.0 REVISION: A1 PACKING ECR/ECN INFORMATION: TITLE: EC No: 122214 SHEET No. ISM 433MHz Flex Antenna DATE: 2017-08-11 DOCUMENT NUMBER: PS-2042870100 1 of 7 CREATED / REVISED BY: CHECKED BY: APPROVED BY: Colin. Xu 2017-08-09 Stary.
PRODUCT SPECIFICATION ISM 433MHz Flex Antenna 1.0 SCOPE This Product Specification covers the mechanical, electrical and environmental performances requirements and test methods for ISM 433MHz Flex Antenna with solder cable. 2.0 PRODUCT DESCRIPTION 2.1 PRODUCT NAME AND SERIES NUMBER (S) Product name: ISM 433MHz Flex Antenna -2042870100 2.2 Design and Construction Antenna construction and physical dimensions specified on the applicable sales drawing. 2.
PRODUCT SPECIFICATION 5.0 PERFORMANCE 5.1 ELECTRICAL REQUIREMENTS FOR CABLE LENGTH 50mm( 2042870050) DESCRIPTION TEST CONDITION REQUIREMENTS Description Test Condition Requirements Frequency Range Measure antenna on recommended PCB through VNA E5071C 433MHz+/-3MHz Return Loss Measure antenna on recommended PCB through VNA E5071C < -10 dB Peak Gain (Max) Measure antenna on recommended PCB through OTA chamber 0.8dBi Avg.
PRODUCT SPECIFICATION 5.3 ELECTRICAL REQUIREMENTS FOR CABLE LENGTH 150mm (2042870150) DESCRIPTION TEST CONDITION REQUIREMENTS Description Test Condition Requirements Frequency Range Measure antenna on recommended PCB through VNA E5071C 433MHz+/-3MHz Return Loss Measure antenna on recommended PCB through VNA E5071C < -10 dB Measure antenna on Peak Gain (Max) recommended PCB through OTA chamber 0.6dBi Avg.
PRODUCT SPECIFICATION 5.5 ELECTRICAL REQUIREMENTS FOR CABLE LENGTH 250mm (2042870250) Description Test Condition Requirements Frequency Range Measure antenna on recommended PCB through VNA E5071C 433MHz+/-3MHz Return Loss Measure antenna on recommended PCB through VNA E5071C < -10 dB Peak Gain (Max) Measure antenna on recommended PCB through OTA chamber 0.4dBi Avg.
PRODUCT SPECIFICATION 5.7 CABLE LOSS ITEM DESCRIPTION TEST CONDITION REQUIREMENT 5.7.1 5.7.2 Frequency Range 433MHz 433MHz Attenuation 1m cable measured by VNA5071C ≤1dB/m 5.8 CABLE LENGTH AFFECT THE ANTENNA PERFORMANCE Balance antenna resonance is insensitive by cable’s length, but the cable’s loss will affect the total Efficiency. Refer to 5.7 5.9 MECHANICAL REQUIREMENTS ITEM DESCRIPTION TEST CONDITION REQUIREMENT 5.9.
PRODUCT SPECIFICATION 5.10.3 5.10.4 Test condition: 1) Temperature:125℃, time:1008hours 1) Parts should meet RF spec 2) There is no substantial obstruction to before and after test. air flow across and around the samples, and the samples are not touching each 2) No cosmetic problem other High Temperature 1.Test condition: The device under test is exposed to a spray of a 5% (by volume) resolution of NaCL in water for 2 1) Parts should meet RF spec hours.
