Datasheet
PRODUCT SPECIFICATION
REVISION:
ECR/ECN INFORMATION:
TITLE:
2.4/5GHZ WIDE DUAL BAND ANTENNA
WITH SIDE SOLDER CABLE
SHEET No.
C
EC No:
171309
9 of 10
DATE:
2018/01/24
DOCUMENT NUMBER:
CREATED / REVISED BY:
CHECKED BY:
APPROVED BY:
PS-2042810100
Kang Cheng 2018/01/24
Colin Xu 2018/01/24
Stary Song 2018/01/24
TEMPLATE FILENAME: PRODUCT_SPEC[SIZE_A4](V.1).DOC
7.0 ENVIRONMENTAL SPECIFICATION
DESCRIPTION
SPECIFICATION
Temperature /Humidity cycling
1.The device under test is kept for 30 mins in an environment with a
temperature of -40 ℃.
2. Kept for 4 Hours in an environment with a temperature of 85 degrees
and a relative humidity of 95%.
3. Kept for 2 Hours in an environment with a temperature of 125
degrees and a relative humidity of 95%.
4. The cycle is repeated until a total of 40 cycles have been completed.
Hereafter the conditions are stabilized at room temperature.
5. Parts meet antenna performance per section 5.0 before and after
test.
6. No cosmetic problem（No soldering problem；No adhesion problem
of glue.
Temperature Shock
1.The device under test at -40 ℃⇔125 ℃ by 100 cycles, Dwell of 30
mins, transition time between Dwell 30 secs (~ 61 mins / cycle) and
each item should be measured after exposing them in normal
temperature and humidity for 24 h.
2. Parts meet antenna performance per section 5.0 before and after
test.
3. No cosmetic problem（No soldering problem；No adhesion problem
of glue）.
High Temperature
1.Temperature:125℃, time:1008 hours
2.There is no substantial obstruction to air flow across and around the
samples, and the samples are not touching each other
3. Parts meet antenna performance per section 5.0 before and after
test.
4. No cosmetic problem（No soldering problem；No adhesion problem
of glue）.
Salt mist test
1. The device under test is exposed to a spray of a 5% (by volume)
resolution of NACL in water for 2 hours. Thereafter the device under
test is left for 1 week in room temperature at a relative humidity of
95%. The cycle is repeated until a total of 2 cycles have been
completed. Here after the conditions are stabilized at room
temperature.
2. Parts meet antenna performance per section 5.0 before and after
test.
3. No visible corrosion. Discoloration is acceptable.