Datasheet

Hand Crimp Tool for Mini-Fit Jr. Male and Female Crimp Terminals
Doc. No: ATS-2002182200 Release Date: 11-30-17 UNCONTROLLED COPY Page 5 of 8
Revision: A Revision Date: 11-30-17
Figure 6
TERMINAL
WIRE AGAINST THE
WIRE STOP
WIRE
WIRE STOP IS PART
OF THE LOCATOR
PRE-STRIPPED
WIRE
TERMINAL
MATCH
UP MARKS
FRONT
BACK
Figure 9
Note: The tamper-proof ratchet action will not release the tool until it has been fully closed.
8. Remove the crimped terminal from the terminal
locator by pulling on the wire.
9. Visually inspect the crimped terminal for proper
crimp location.
10. On some large O.D. wires, it may not be possible to
insert the wire with the tool partially closed. Those
wires should be inserted with the hand tool in the
open position. Insert the wire above the terminal in
the punch and against the wire stop, and then close
the tool. See Figure 7.
Right or Left Hand Operation
This hand tool has an added feature that can be converted from a right-handed application to a
left-handed application. It is necessary to reverse the tooling if using the left-handed application
along with the locator. Follow the steps below:
1. The locator must be removed before
reversing the tooling.
2. Remove the M3 BHCS, which is holding
the upper tooling.
3. Flip the upper tooling to the opposite side,
and replace the M3 BHCS. Make sure the
small markings on the front and back of
the hand tool frame match up and are on
the outside of the hand tool frame. See
Figures 8 and 9.
4. Do the same thing with the lower tooling,
and tighten the M3 screws. Be sure the
small markings line up.
5. Reinstall the locator by following the
instructions in the locator replacement
section.
TERMINAL
Figure 7
WIRE
WIRE
STOP
Figure 8
PUSH ON
HANDLE
JAWS OPEN
PULL OPEN
TOOLING
TOOLING
M3 BHCS