Datasheet

Hand Crimp Tool for Mini-Fit Sr. Crimp Terminals
Doc No: ATS-2002181600 Release Date: 10-19-17 UNCONTROLLED COPY Page 3 of 6
Revision: A Revision Date: 10-19-17
3. To move the locator, first rotate the locking tab down 90 degrees.
4. The locator should swing freely away from the tool.
5. The locator cover needs to be lifted to insert or remove a terminal.
Note
This tool also has a hinged handle to aid in one-handed operation.
1. With the hand tool in the open position, push down on the ridged handle
release tab on the inside of the hinged handle.
2. While holding the ridged tab down, bend the lower portion of the handle
to engage the hinge. See Figure 4.
As you close the handle to crimp a terminal, the hinged handle will contact
the straight handle before the crimp is complete.
You must straighten out the hinged handle and squeeze the handles
together to complete the crimp.
HINGED HANDLE
Figure 4
HANDLE
RELEASE TAB
LOCKING TAB
LOCATOR
LOCATOR
COVER
Figure 3