Datasheet

Extractor Tool for Mini-Fit ™ Series Terminals
Doc No: ATS-011030044 Release Date: 03-01-05 UNCONTROLLED COPY Page 2 of 3
Revision: F Revision Date: 04-16-08
TERMINAL
EXTRACTOR
TOOL
PULL WIRE AND
TERMINAL
SLOTS FOR
EXTRACTOR
TOOL
HOUSING
Figure 1
Terminal Series No. Terminal Order No.
45750-1111 45750-1112 45750-1211 45750-1212 45750-3111 45750-3112
45750
45750-3211 45750-3212 45750-4111 45750-4112 45750-4211 45750-4212
46012-1141 46012-1142 46012-1241 46012-1242 46012-3141 46012-3142
46012
46012-3241 46012-3242
46018 46018-1541 46018-1542 46018-2541 46018-2542 46018-3541 46018-3542
46083-1111 46083-1112 46083-1121 46083-1122 46083-1211 46083-1212
46083-1221 46083-1222 46083-2111 46083-2112 46083-2121 46083-2122
46083-2211 46083-2212 46083-2221 46083-2222 46083-3111 46083-3112
46083
46083-3121 46083-3122 46083-3211 46083-3212 46083-3221 46083-3222
46098 46098-1541 46098-1542 46098-2541 46098-2542 46098-3541 46098-3542
OPERATION:
1. Insert the extractor tool into the housing as shown in Figure 1.
2. Use the slots located on the inside of the housing to guide the extraction tool blades into the housing until
contact is made with terminal.
3. Continue to insert the tool always checking to see that the blades of extraction tool are on the outside of the
contact as shown in Figure 2.
4. Continue to insert extraction tool into housing until the locking tangs have snapped out of their locked
position. If the terminal locking tabs are still not totally depressed, hold on tight to the wire and push it
towards the extractor tool, this will completely depress the locking tabs. See Figure 2.
5. Gently pull the terminal by the wire, out from the housing.