Datasheet

HT60923A Extractor Tool
Doc No: ATS-011030043 Release Date: 02-02-95 UNCONTROLLED COPY Page 3 of 3
Revision: D Revision Date: 05-14-08
TERMINAL
PUSHED IN
LOCKING TANG
PUSHED
DOWN
EXTRACTOR
TOOL ON AN ANGLE
HOUSING
5014
8
-
8*00 TE
RMINAL
ROTATE THE
EXTRACTOR
TOOL UP
Figure
5
EXTRACTOR
TOOL
HOUSING
50147
-
8*00
TERMINAL
LOCKING TANG
PUSHED
UP
TERMINAL
PUSHED IN
ROTATE THE
EXTRACTOR TOOL
DOWN
For 50147 and 50148 Terminal Series:
Individual terminals may be extracted from the housing using this Tool.
1. For terminal series 50147, push the terminal forward in the arrow direction before using the Extractor Tool.
2. Insert the tip of the Extractor Tool on an angle above the terminal into the slot on the top of the connector
housing.
3. While rotating the extraction tool down, bend the terminal locking tang down and push the terminal back
through the connector slot. Make sure that the terminated wire is pulled out at the same time. See Figure 5.
4. For terminal series 50148, push the terminal forward in the arrow direction before using the Extractor Tool.
5. Insert the tip of the Extractor Tool on an angle above the terminal into the slot on the bottom of the connector
housing.
6. While rotating the extraction tool up, bend the terminal locking tang down and push the terminal back through
the connector slot. Make sure that the terminated wire is pulled out at the same time. See Figure 6.
Molex does not offer repair parts for this Tools due to the inexpensive nature of the tool
CAUTION: Molex specifications are valid only when used with Molex terminals, applicators and tooling.
Americas Headquarters
Lisle, Illinois 60532 U.S.A.
1-800-78MOLEX
[e-mail]
Far East North Headquarters
Yamato, Kanagawa, Japan
81-462-65-2324
[e-mail]
Far East South Headquarters
Jurong, Singapore
65-6-268-6868
[e-mail]
European Headquarters
Munich, Germany
49-89-413092-0
[e-mail]
Corporate Headquarters
2222 Wellington Ct.
Lisle, IL 60532 U.S.A.
630-969-4550
Fax: [phone]
Visit our Web site at http://www.molex.com