Datasheet

HT60923A Extractor Tool
Doc No: ATS-011030043 Release Date: 02-02-95 UNCONTROLLED COPY Page 1 of 3
Revision: D Revision Date: 05-14-08
Extractor Tool
Instruction Sheet
Order No. 11-03-0043
Engineering No. HT60923A
FEATURES
 This tool is designed to extract series 43030, 43031, and 46235 terminals from crimp housings (Series 43020,
43025, 43645, and 44133)
 This tool is designed to extract series 50058, 50061, 50079, and 50080 terminals from crimp housings (Series
51021 and 51022)
SCOPE
Products: Micro-Fit 3.0™ and 1.25mm (.049") Pitch PicoBlade™ Crimp Terminals.
Terminal
Series No.
Terminal Order No.
43030-0001 43030-0002 43030-0003 43030-0004 43030-0005 43030-0006 43030-0007 43030-0008
43030-0009 43030-0010 43030-0011 43030-0012 43030-0051 43030-0052 43030-0053 43030-0056
43030
43030-0057 43030-0058 43030-0059 43030-0080 43030-0081 43030-1001
43031-0001 43031-0002 43031-0003 43031-0004 43031-0005 43031-0006 43031-0007 43031-0008
43031-0009 43031-0010 43031-0011 43031-0012 43031-0016 43031-0017 43031-0018 43031-0019
43031
43031-0051 430310052 430310053 43031-0057 43031-0059 43031-0102 43031-0103 43031-0106
46235 46235-0001 46235-0002 46235-0003 46235-0004
50058 50058-8000 50058-8099 50058-8100 50058-8200 50058-8300 50058-8400 50058-8500
50061 50061-8000 50061-8018 50061-8028 50061-8099 50061-8100 50061-8118 50061-8128
50079 50079-8000 50079-8000 50079-8053 50079-8099 50079-8100 50079-8153
50080 50080-8000 50080-8100
50147 50147-8000 50147-8100
50148 50148-8000 50148-8100
OPERATION:
For 43030, 43031, and 46235 Terminal
Series:
Individual terminals may be extracted from the
housing using this Tool.
1. Insert the tip of the tool on either side of the
terminal until it stops. See Figure 1.
2. Rotate tool clockwise then counter-clockwise
approximately 25º to 30º in each direction, once
or twice.
3. Repeat steps 1 and 2 on the opposite side of
terminal.
Figure 1
EXTRACTOR
TOOL
HOUSING
TERMINAL
LOCKING TANGS
PUSHED IN