Datasheet

HT-71800 Extractor Tool
Doc No: ATS-011030036 Release Date: 05-29-85 UNCONTROLLED COPY Page 3 of 3
Revision: F Revision Date: 01-20-17
Housing Extraction:
This operation is used to remove a housing from an interim clip or panel mount clip.
1. Slide the SL tool under the plastic tab on the clip or panel mount and lift up. Carefully open only far enough to
extract the housing.
2. Pull the housing out in the direction of the arrow. See Figure 5 and 6.
Molex does not offer repair parts for Extractor Tools due to the inexpensive nature of these tools.
CAUTION: Molex specifications are valid only when used with Molex terminals and tooling.
Visit our Web site at http://www.molex.com
Figure 5
CLIP INTERIM
HOUSING
WIRE
CLIP
SL TOOL
SL TOOL
PANEL MOUNT
WIRE
HOUSING
Figure 6
PANEL MOUNT