Datasheet

HTA2174 Extractor Tool
Doc No: ATS-011030016 Release Date: 01-31-02 UNCONTROLLED COPY Page 3 of 3
Revision: K Revision Date: 02-15-16
Figure 4
EXTRACTOR
TOOL
HOUSING
LOCKING TANG
PUSHED UP
TERMINAL
PUSHED IN
Figure 3
EXTRACTOR
TOOL
HOUSING
TERMINAL
LOCKING LATCH
PUSHED DOWN
TERMINAL
PUSHED IN
PUSH THE EXTRACTOR
FORWARD AGAINST THE
STOP ON THE LATCH
For 50837 Terminal Series:
1. For terminal series 50837, push the terminal forward in the arrow direction before using the Extractor Tool.
2. Insert the tip of the Extractor Tool below the pin of the terminal in the front end opening of the connector.
3. Push the Extractor Tool forward, between the terminal and locking latch in the housing, until it stops. This will
separate the latch from the terminal.
4. Depress the locking latch and pull the wire and terminal back through the connector slot. See Figure 3.
NOTE: Figure 3 does not show an exact representation of the 51198 housing.
For 172253 Terminal Series:
1. Push the terminal forward in the arrow direction before
using the Extractor Tool as shown in Figure 4.
2. Insert the Extractor Tool into the slot on the side of the
connector housing.
3. Depress the terminal locking tang and push the
terminal back through the connector slot.
3. Pull the terminated wire out. See Figure 4.
CAUTION: This extractor tool should be used to extract the terminal only. Using it for unintended purposes may
cause injury or damage to parts. Be careful not to deform the end of the terminal.
CAUTION: Molex specifications are valid only when used with Molex terminals, applicators and tooling.
Molex does not offer repair parts for Extractor Tools due to the inexpensive nature of these tools.
Contact Information
For more information on Molex application tooling please contact Molex at 1-800-786-6539.
Visit our Web site at http://www.molex.com