MSDS

ManualsBrandsMoldex ManualsKitchen32 oz. Instant Mold and Mildew Stain Remover

#25706

Page: 1 of 8

Issue date 10-March-2015

SAFETY DATA SHEET

1. Product and Company Identification

Product identifier Moldex Instant Mold and Mildew Stain Remover

Other means of identification

Not available

Recommended use

Stain remover

Recommended restrictions

None known.

Manufacturer

EnviroCare Corporation

10 Upton Drive

Wilmington, MA 01887 US

Phone 1-978-658-0123

Emergency Phone - CHEMTREC

(US/Canada): 1-800-424-9300

(Intl/Maritime): +1-703-527-3887

2. Hazards Identification

Physical hazards

Health hazards

Environmental hazards

OSHA defined hazards

Label elements

Hazard symbol

Not classified.

None.

Signal word

None.

Hazard statement

The mixture does not meet the criteria for classification.

Precautionary statement

Prevention Observe good industrial hygiene practices.

Response If swallowed: Rinse mouth. Do NOT induce vomiting.

Storage Store away from incompatible materials.

Disposal Dispose of waste and residues in accordance with local authority requirements.

Hazard(s) not otherwise

classified (HNOC)

None known.

Supplemental information This product is not subject to 29 CFR HCS 1910.1200 regulations.

The following HCS exemption for consumer products applies; 29 CFR 1910.1200(b)(6)(ix).

3. Composition/Information on Ingredients

Mixture

Chemical name Common name and synonyms

CAS number %

Sodium hypochlorite

N,N-dimethyl-1-tetradecanamine,

N-oxide

Sodium metasilicate

7681-52-9

3332-27-2

6834-92-0

3 - 7

0.1 - 1

Composition comments

This product is regulated by the CCCR (Consumer Chemicals and Containers Regulations, 2001)

& the CPSC (Consumer Product Safety Commission). The exact % concentration of composition

has been withheld as a trade secret in accordance with paragraph (i) of the OSHA HCS

1910.1200.

4. First Aid Measures

Inhalation

If symptoms develop move victim to fresh air. If symptoms persist, obtain medical attention.

Skin contact

Immediately flush with cool water for 15 minutes while removing contaminated clothing and shoes.

Discard or wash well before reuse. Obtain medical advice immediately.

Eye contact

Immediately flush with cool water. Remove contact lenses, if applicable, and continue flushing for

15 minutes. Obtain medical attention immediately.

Ingestion

If vomiting occurs naturally, have victim lean forward to reduce risk of aspiration. Never give

anything by mouth if victim is unconscious, or is convulsing. Obtain medical attention.

Summary of content (8 pages)

PAGE 1
SAFETY DATA SHEET 1. Product and Company Identification Product identifier Other means of identification Moldex Instant Mold and Mildew Stain Remover Not available Recommended use Stain remover Recommended restrictions None known. Manufacturer EnviroCare Corporation 10 Upton Drive Wilmington, MA 01887 US Phone 1-978-658-0123 Emergency Phone - CHEMTREC (US/Canada): 1-800-424-9300 (Intl/Maritime): +1-703-527-3887 2. Hazards Identification Physical hazards Not classified.
PAGE 2
Most important symptoms/effects, acute and delayed Causes serious eye irritation. Symptoms may include stinging, tearing, redness, swelling of the eyes, and blurred vision. Indication of immediate medical attention and special treatment needed Treat symptomatically. General information If you feel unwell, seek medical advice (show the label where possible). Show this safety data sheet to the doctor in attendance. Avoid contact with eyes and skin. Wear rubber gloves and chemical splash goggles.
PAGE 3
8. Exposure Controls/Personal Protection Occupational exposure limits US. AIHA Workplace Environmental Exposure Level (WEEL) Guides Components Type Sodium hypochlorite (CAS 7681-52-9) STEL Value 2 mg/m3 Biological limit values No biological exposure limits noted for the ingredient(s). Exposure guidelines Chemicals listed in section 3 that are not listed here do not have established limit values for ACGIH or OSHA PEL. Ensure adequate ventilation.
PAGE 4
10. Stability and Reactivity Reactivity Possibility of hazardous reactions Reacts violently with acids. May react with incompatible materials. Hazardous polymerization does not occur. Chemical stability Stable under recommended storage conditions. Conditions to avoid Incompatible materials Do not mix with other chemicals. Contact with incompatible materials. Oxidizing agents. Acids. Hazardous decomposition products May include and are not limited to: Hydrogen chloride. Chlorine. Oxides of nitrogen.
PAGE 5
Not available. Oedema value Causes irritation. Serious eye damage/eye irritation Corneal opacity value Not available. Iris lesion value Not available. Conjunctival reddening value Not available. Conjunctival oedema value Not available. Recover days Not available. Respiratory or skin sensitization Respiratory sensitization Not available. Skin sensitization This product is not expected to cause skin sensitization.
PAGE 6
Contaminated packaging Since emptied containers may retain product residue, follow label warnings even after container is emptied. 14. Transport Information U.S. Department of Transportation (DOT) Basic shipping requirements: UN number UN3082 Environmentally hazardous substances, liquid, n.o.s.
PAGE 7
SARA 313 (TRI reporting) Not regulated. Other federal regulations Safe Drinking Water Act (SDWA) Food and Drug Administration (FDA) US state regulations Not regulated. Not regulated. This product does not contain a chemical known to the State of California to cause cancer, birth defects or other reproductive harm. US - California Hazardous Substances (Director's): Listed substance Sodium hypochlorite (CAS 7681-52-9) Listed.
PAGE 8
Prepared by Dell Tech Laboratories, Ltd. Phone: (519) 858-5021 Other information This Safety Data Sheet was prepared to comply with the current OSHA Hazard Communication Standard (HCS) adoption of the Globally Harmonized System of Classification and Labeling of Chemicals (GHS). This SDS conforms to the ANSI Z400.1/Z129.1-2010 Standard.