MSDS

MSDS / 5002 1 of 2
1. CHEMICAL PRODUCT & COMPANY IDENTIFICATION
PRODUCT NAMES: MOLDEX PROTECTANT
MANUFACTURER: EnviroCare Corporation
260 Fordham Road
Wilmington, MA 01887
Tel# [phone] Fax# [phone]
Emergency Contact: CHEMTREC 1-800-424-9300 (24 Hours)
Prepared by: EnviroCare Revised: 4/06/06
2. INFORMATION ON INGREDIENTS
Unlisted ingredients are not ‘hazardous’ per the occupational Safety and Health Administration Hazard Communication
Standard (29 CFR 1910.1200) and/or are not found on the Canadian Workplace Hazardous Materials Information System
ingredient disclosure list. See section 5 for any additional exposure limit guidelines.
COMPONENT CAS
NUMBER
WT%
+/-
OSHA
TWA STEL
ACGIH
TWA STEL
- - - - - - -
3. FIRE AND EXPLOSION HAZARD DATA
NOTE: THIS MATERIAL WILL NOT NORMALLY BURN.
FLASH POINT: N/A LOWER EXPLOSIVE LIMIT: N/A UPPER EXPLOSIVE LIMIT: N/A
EXTINGUISHING MEDIA: Water Spray, Carbon Dioxide, Foam
SPECIAL FIREFIGHTING MEASURES: Wear self-contained breathing apparatus and full protective gear. Material may
splatter if temperatures exceed boiling point (212F)
4. PHYSICAL DATA
q ODOR: Characteristic APPEARANCE: Thick Milky Aqueous Liquid
q SOLUBILITY IN H
2
O: Dilutable VBW %: 48%
q VAPOR DENSITY: Heavier than Air
5. HEALTH HAZARD DATA
Independent animal tests conducted according to OSHA Hazard communication Standard 29CFR1910.1200 confirms that
the mixture is NON-TOXIC and is not an eye irritant.
q EFFECTS OF OVEREXPOSURE – EYE CONTACT: No irritation hazard in normal industrial use.
q EFFECTS OF OVEREXPOSURE – SKIN CONTACT: No irritation hazard in normal industrial use.
q EFFECTS OF OVEREXPOSURE – INHALATION: No irritation hazard in normal industrial use.
q EFFECTS OF OVEREXPOSURE – INGESTION: Ingestion is not an anticipated route of exposure. No hazard in normal
industrial use.
q EFFECTS OF OVEREXPOSURE – CHRONIC HAZARDS: No organs known to be damaged by exposure to this product.
q CARCINOGENICITY: Unless noted below, this product does not contain regulated levels of NTP, IARC , ACGIH, or
OSHA listed carcinogens.
q FIRST AID – EYE CONTACT: None expected to be needed. Eye wash is recommended to remove chemical from eyes.
q FIRST AID – SKIN CONTACT: Wash with soap and water.
q FIRST AID – INHALATION: This product does not present a hazard if inhaled. Remove individual to fresh air after an
airborne exposure if any symptoms develop, as a precautionary measure.
q FIRST AID – INGESTION: Do not induce vomiting. Seek medical attention if symptoms develop. Provide medical
care provider with this MSDS.