Technical Specifications

TECHNICAL DATA
MDX-01
MOLDEX
®
MOLD KILLER
1
Form: ARJ-1405
Rev.: 101717
DESCRIPTION AND USES
Moldex
®
Mold Killer kills mold and inhibits mildew. Mold
Killer is effective against a broad spectrum of bacteria,
virucidal, fungicidal, and inhibits the growth of mildew and
their odors when used as directed. Cleans with a fresh
scent. Eliminates odors.
It is a violation of Federal law to use this product in a
manner inconsistent with its labeling.
EPA REG. NO. 6836-193-82480
PRODUCTS
SKU
DESCRIPTION
5006
22oz. Bottle
5010
32oz. Bottle
5520
1 Gallon
5600
5 Gallons
PERFORMANCE CHARACTERISTICS
 Bleach Free
 Kills Mold
 Inhibits the growth of mold and mildew
 Cleans, deodorizes and disinfects
 Commercial and Industrial use
PRODUCT APPLICATION
DISINFECTION DIRECTIONS
Preclean prior to disinfection. Spray 6-8 inches from
surface, until surfaces are thoroughly wet. Do not breathe
spray. Treated surfaces must remain wet for 1 minute for
disinfection against bacteria. Follow virucidal or Fungicidal
directions when using as a virucidal or fungicidal agent.
Wipe dry with a clean cloth, sponge, mop or allow to air dry.
Food contact surfaces must be rinsed with potable water
after disinfection. Do not use on utensils, glassware and
dishes.
PRODUCT APPLICATION (cont.)
SURFACE PREPARATION (cont.)
VIRUCIDAL DIRECTIONS
Follow disinfection directions for application instructions.
Treated surfaces must remain wet for 10 minutes for
Herpes Simplex Type 2 and 60 seconds for Influenza/Hong
Kong.
MOLD AND MILDEW CONTROL DIRECTIONS
Moldex Mold Killer effectively inhibits the growth of mold
and mildew and the odors caused by them when applied to
hard, nonporous surfaces. Follow disinfection instructions.
Allow to air dry on surface. Repeat every 7 days, or when
mold or mildew growth returns.
FUNGICIDAL DIRECTIONS
Moldex Mold Killer is an effective fungicide against
Trichophyton mentagrophytes (the Athlete’s Foot Fungus)
(a cause of ringworm) in areas such as locker rooms,
dressing rooms, shower and bath areas, exercise facilities,
health clubs and spas. Follow disinfection directions for
application instructions. Treated surfaces must remain wet
for 10 minutes.
This product is not for use on medical device surfaces.
KILLS HIV ON PRE-CLEANED ENVIROMENTAL
SURFACES/OBJECTS PREVIOUSLY SOILD WITH
BLOOD/BODY FLUIDS in health care settings or other
settings in which there is an expected likelihood of soiling of
inanimate surfaces/objects with blood or body fluids and in
which the surfaces/objects likely to be soiled with blood or
body fluids can be associated with the potential for
transmission of Human Immunodeficiency Virus Type 1
(HIV-1).
SPECIAL INSTRUCITONS FOR CLEANNING AND
DECONTAMINATION AGAINST HIV-1 ON
SURFACES/OBJECTS SOILED WITH BLOOD/BODY
FLUIDS.
Personal Protection: Clean-up must always be done
wearing protective gloves, gowns, masks and eye
protection.
Cleaning Procedure: Blood and other body fluids
containing HIV must be thoroughly cleaned from surfaces
and objects before application of Moldex Mold Killer.
Contact Time: Leave surface wet for 30 seconds. Use a 1
minute contact time for disinfection against Influenza
A/Hong Kong Influenza and bacteria and a 10 minute
contact time against all other viruses and fungi claimed.