Introduction for installation manual: Installation Manuel for Unman aged PoE Switch, mainly Introduces hardware characteristics of switch, method of installation, definition of interface and indicator, and precautions in the installation. Note: Pleads read the manual carefully before your installation, to avoid possible damage for the product and personal injury during the process.
Chapter 1: Application Scope The manual is suitable for: 1.4 ports fast theme Poet switch 2.4 ports gigabit Poet switch 23.8 ports fast theme Pot+ switch 4.8 ports fast Ethernet Poet switch with efp port £.16 pores fast theme Poet switch 8.24 pols fast theme Pot switch Chapter 2: Product Introduction The Pol switch is independently innovated, researched and developed, sped ally designed for satisfying needs of PoE.
Chapter 4: Methods of installation and precautions 1.Packing List Open the packing box carefully, confirm the items should be as follows: 1). pcs PoE switch 2). apes AC power cable 3). pcs user menus 43. Apes hangers, screws with news (apes screw on 4/8 port PoE switch, poss on 18/24 ports ) 8). sped Mats PS: Please contact the local dealer timely if you find the accessories missed or damaged. 2.
3.Precautions for installation Sore practical measures might be talent deal with the interference under the condition, { Warning: i Is Allover products, which might cause wireless interference in the Irving environment. | Nita: Piazzas obey fhe precautions below io avoid product damaged and personal injury caused by improper using. 3.1.Precautions Tor installation: ® Please cheap the power off riding the hols installation.
for Lightning Preclusion It will cause the fatal damage to the electronics device by the cosmopolitan powerful current when the fighting scours. To achieve the beret effect of lightning protraction, pi sass pay attention in the below: @ Confirm the rack with good grounding; 8 Confirm the power outset with good grounding; # Reasonable wiring fo avoid lightning internal induction; #8 Recommend usage of signal lightning arrested when wiring outdoor SE).
Step 2: Planning the position of the switch Installation In the cabinet and install the floating mts iv the sailed position of the front hols of the cabins Stan 3: One Installer holds the bottom of the swish by hands and move the switch to the settled position; another installer foes the hangers to the front hols of the cabinet by floating nuts with the sowers. a & Holes for the front cabinets a Front pans! of switch &@ Front hangers 5.
§.2.Connect to the SFP Port Einstein the fiber end fo the SFP port until the fiber end kept in good contacts with the switch, as shown as illustration 5-2 BFP port Fiber and Fiber cable confirm the Fx and Tx port of the fiber and when connects, Insert one end of the optical fiber to the Ry and Tx port and confirm the correction of the connection on the Tx and Rx pork; Another end fo the another device; check the condition of the corresponding indicator when electrified.
