User Manual Part 6

Administration Tab
SpectraGuard® Enterprise User Guide
320
that particular sensor. The configuration of Syslog server IP to which the sensor access logs are to be sent, is done
through
the Sensor Access Log tab.
The following screen shows the Sensor Access Log tab.
Sensor Access Logs
The following fields are present in the Sensor Access Logs tab:
Enable Sensor Access Logging: Select the Enable Sensor Access Logging check box, to enable sending of sensor
access logs to a Syslog server. This checkbox is deselected, by default.
Syslog Server IP address/DNS name: Specify the IP address or DNS name of the Syslog server to which the sensor
access logs are to be sent in this field. IPv4 addresses are allowed in this field. This field is blank and disabled, by
default. It is enabled when you select the Enable Sensor Access Logging check box.
Click Save, to save the Sensor Access log settings.
Click Cancel, to cancel any changes made to this tab.
Click Restore Defaults, to restore default values of the fields in the Sensor Access Log tab.
Once sensor access logging is enabled, the sensor reboots and starts sending information to the Syslog server at the IP
address specified through this tab.