User Manual Part 6

Administration Tab
SpectraGuard® Enterprise User Guide
316
Antenna Selection and Port Assignment-SS-300-AT
2 For Antenna Selection for SS-300-AT Sensor
 Select Internal or External in Antenna Selection.
The default configuration for SS-300-AT sensors is to use internal antennas. If you want to connect external antennas
to SS-300-AT sensors, select External radio button. This enables:
 Antenna Ports Used: Six external antenna ports are available in every SS-300-AT type sensors. Out of these six
ports, three ports are for 5 GHz and three for 2.4 GHz. Depending upon number of external antennas connected; click
the checkboxes corresponding to the antenna ports in the sensor template. Indentation marks are provided on the
sensor enclosure describing the radio and antenna port, like 5G Ant1, 2.4G Ant2, and so on.
 Antenna Model: Select the appropriate antenna model for 2.4 GHz and 5GHz antennas from the drop down list.
The antenna models available are SS-300-AT-AN-10 is recommended for Indoor use, SS-300-AT-AN-20 is
recommended for Outdoor use, SS-300-AT-AN-40 is recommended for Outdoor use. Select Other and enter the
antenna model of your choice in the Enter Antenna Model field.
Recommendation: It is recommended that you should use AirTight™ certified antennas for better coverage and
performance. If you are using Other Antenna Model, please make sure that they comply with the SS-300-AT
sensor’s electrical characteristics.