User Manual Part 6

Administration Tab
SpectraGuard® Enterprise User Guide
314
Additionally, specify the intrusion prevention level that allows you to choose a trade-off between the desired level of
prevention and the desired number of multiple simultaneous preventions across radio channels. You can choose
either of the following prevention levels:
 Block
 Disrupt
 Interrupt
 Degrade
Antenna Selection and Port Assignment
Antenna connectivity setting is an advanced setting and should be used with utmost care. This setting allows you to
provide additional information about the type of antennas connected to the sensor. You need to change this setting
only if you use sensors that allow you to connect antennas.
Note: Antenna Selection feature is available for SS-300 Sensor and Port Assignment feature is available for SS-
200 Sensor.
Applying a template with a particular antenna setting to a sensor with incompatible antenna connection can result in
a loss of system functionality leading to higher security risks. The default setting being “Diversity On”. It is
recommended that you avoid changing the Antenna Port Setting in the default sensor template. If you use sensors
with 2 single band antennas, create a separate template with “Diversity Off” setting and manually apply it to a group
of sensors which use single band antennas.
Note: The default setting is “Diversity On” which means both the antennas are dual band.