User Manual Part 6

Administration Tab
SpectraGuard® Enterprise User Guide
305
Frame
Aggregation
This field specifies the enabling or disabling of MPDU
aggregation
This field is 802.11n specific.
When in AP mode, a single physical AP device can be logically split up into multiple virtual AP's. Each wireless
profile represents the configuration settings of a virtual AP. Click Add New Profile to select the SSID profiles for the
AP. Each SSID profile corresponds to a virtual AP. Upto 8 virtual APs can be configured on one radio.
Similar settings apply to SS-300-AT-C-50. SS-300-AT-C-50 has a single radio. It can be configured to work as an AP or
as a WIPS sensor.
SS-300-AT-C-10 and SS-200-AT-01 can function as WIPS sensors only. Hence fields related to radio settings are
disabled on these tabs.
Channel Settings
Channel Settings displays the 802.11a/802.11b/g and Turbo channels on which scanning and defending is
enabled/disabled. Sensors scan WLAN traffic on channels specified under Channels to Monitor and defend the
network against various WLAN threats on channels specified under Channels to Defend.
 Under Channel Settings tab, specify the following:
 Select Operating Region: Specifies the region / country of operation. Each region has its own laws governing the
use of the unlicensed frequency spectrum for 802.11 communications and Turbo mode. The system automatically
selects the channels that are allowed by the regulatory domain in selected region.
(Default Operating Region: United States)
 Click the link Channel Frequency Table to view a list of channels, protocols, frequencies, and capabilities.