User Manual Part 6

Administration Tab
SpectraGuard® Enterprise User Guide
293
Network Settings
Configure the VLAN and DHCP settings to be used be the NAT device using the Network Settings tab.
VLAN ID: Specify the VLAN ID.
Start IP address: Specify the starting IP address of the DHCP address pool in the selected network ID.
End IP address: Specify the end IP address of the DHCP address pool in the selected network ID.
Local IP address: Specify an IP address in selected network ID outside of the DHCP address pool. This address is
used as the gateway address for the guest wireless network.
Subnet Mask: Specify the netmask for the selected network ID.
Lease Time: Specify the DHCP lease time.