User Manual Part 5
Administration Tab
SpectraGuard® Enterprise User Guide
227
Error: This state indicates an error in HA state. Contact Technical Support.
Cluster IP Address: This IP Address can be used by the Console and Sensors to connect to the HA cluster. This
is a virtual IP Address used to connect to the HA cluster. Cluster IP address is optional. It can not be used in Layer3
HA configuration.
Data Sync State: Displays the state of data synchronization from Active Server to Standby Server after enabling
HA Service or after database operation such as database restore.
Data Sync Link: Data sync link is the link which carries data from the Active Server to Standby. HA interface or
Network Interface can be used as ‘Data Sync Link’ between the servers. During HA setup, user can skip use of HA
interface.
This field indicates whether two servers are reachable over ‘Data Sync Link’ interface.
HA Failover Mode: Indicates HA failover mode – Automatic/Manual.
Active Server: This section displays IP addresses of the Active server.
Network IP Address: This is the IP Address of the network interface of the Active server.
HA IP Address: This is the IP Address of the HA interface of the Active server.
Standby Server: This section displays IP Addresses of the Standby Server.
Network IP Address: This is the IP Address of the network interface of the Standby server.
HA IP Address: This is the IP Address of the HA interface of the Standby server.
Login Configuration
The system enables you to configure a login message through the Login Configuration screen. Superuser of the
system has the right to enter the login message that will be flashed in the Login screen.