User Manual Part 5

Administration Tab
SpectraGuard® Enterprise User Guide
249
IF MIB
Host Resources MIB
AirTight-MIB: If selected, the system enables the external SNMP Trap receivers to receive traps
MIB-II: If selected, configure the System Contact, System Name, and System Location.
(Default System Name: Wi-Fi Security Sever)
Note: IF MIB, Host Resources MIB, an MIB II are standard MIBs that you can download from the Internet. For
AirTight-MIB, contact AirTight Technical Support.
Adding a SNMP Trap Destination Server
Under SNMP Trap Destination Servers, click Add to open SNMP Configuration dialog where you can add
SNMP server details.
Add SNMP Configuration Dialog
Trap Destination Details contains the following fields:
Destination Server (IP Address/Hostname): Specifies the IP address or the hostname of the SNMP server to
which events should be sent.
Note: Configured SNMP servers will use the DNS names and DNS suffixes configured by the user in the Server
Initialization and Setup Wizard on the Config Shell.
SNMP Protocol Version: Specifies the SNMP protocol version for the SNMP agent.
(Default: SNMP v1, v2)
Port Number: Specifies the port number on the receiving system to which the SNMP trap is sent.
(Default: 162)
Enabled?: Specifies if the SNMP server is enabled to receive SNMP traps.
(Default: Enabled)
Note: You must specify a different port number if another application uses the default port.
Click Add to add the details for a new SNMP server.