User Manual Part 5

Administration Tab
SpectraGuard® Enterprise User Guide
236
System server is stopped
Internal error, in which case you need to contact Technical Support
Imported APs: This percentage indicates total number of APs imported from WLC(s) as a fraction of maximum
allowed. The maximum allowed depends on type of appliance. The status displayed is as of the last synchronization
event. It is recommended that the utilization remains below 80%. If the utilization exceeds 80%,the system
performance may degrade and result in side effects such as sluggish UI and sensor disconnections.
Under Automatic Synchronization Settings, select the System-WLC synchronization interval.
Synchronization Interval (Minutes): Specifies the interval for which the server synchronizes with the WLC
(Minimum: 15 minutes; Maximum: 60 minutes; Default: 30 minutes)
If the customer has some Lightweight Access Points (LAPs) whose type (like ap1030, ap1130) is not supported
by SGE, then these LAPs can be supported by importing the WLC configuration bundle received from the AirTight
Support on request. After the bundle is received, click <Advanced Configuration> The Import Custom WLC
Configuration File dialog appears. The custom WLC configuration file from this bundle is used for all future WLC
synchronization. The bundle is imported as .tgz.
Import Custom WLC Configuration File Dialog
Click Browse to specify the appropriate location of the WLC Configuration bundle and click <Import>, a progress bar
appears. After the file is imported, the date and time when file was imported is displayed as in the screen.
Import Custom WLC Configuration File Dialog showing date and time of the file imported
If the file is not imported for some reason or if the file is corrupted, an error message is displayed.
Note: Only the Super User is allowed to import WLC configuration file. All other users, including the
administrator has only the viewing rights.
Adding a WLAN Controller
Under Wireless LAN Controllers, click <Add> to open WLAN Controller dialog where you can add WLC details.