User Manual Part 3

Locations Tab
SpectraGuard® Enterprise User Guide
138
3. Change the values of the Signal Decay Slope (Beta) and the Signal Decay Inflection (Alpha). The
system uses these parameters when computing the RF and defines the region around the transmitter
that is unobstructed.
Note: When you change the Min. Signal Decay Constant, Max. Signal Decay Constant, Signal Decay Slope (Beta), and
Signal Decay Inflection (Alpha) the RF view and location tracking for unobstructed regions is affected. In the obstructed
regions, only Location Tracking is affected, RF view is not affected.
4. Click Update Graph to view your selection against the predicted values.
Important: The Predicted value curve should overlap the Observed value curve as much as possible.
5. Click Calibrate to complete calibration if you have adjusted the parameters manually such that the two
curves are parallel (but not coinciding).
6. Click Apply to commit your changes.
RF Calibration Dialog