User Manual Part 2
Devices Tab
SpectraGuard® Enterprise User Guide
94
Sensor Location Tag Dialog
You cannot change the location of a Sensor placed on a floor map. If you attempt to do so, an error message appears.
A Sensor placed on a floor map is automatically assigned the location tag of that location. To change the location tag,
you must first delete the Sensor from the floor map.
Placed on Floormap?: Indicates if the Sensor is placed on the floor map.
Currently Active?: Indicates if the Sensor is currently active.
Up/Down Since: Indicates the time since the Sensor is up/down.
Channels Scanned (a): Specifies the 802.11a channels on which Sensor is configured to scan.
Channels Defended (a): Specifies the 802.11a channels on which the Sensor is configured to defend.
Channels Scanned (b/g): Specifies the 802.11 b/g channels on which Sensor is configured to scan.
Channels Defended (b/g): Specifies the 802.1b/g channels on Sensor is configured to defend.
Channels Scanned (Turbo a): For turbo APs, specifies the 802.11a channels on which the Sensor is
configured to scan.
Channels Scanned (Turbo b/g): For Turbo APs, specifies the 802.11 b/g channels on which the Sensor is
configured to scan.
Busy in Quarantine? Indicates if the Sensor is currently busy quarantining a device. The quarantine status is
always displayed in the Quarantine Status field in the header of the Sensor Details dialog for every tab.
Sensor Software Build: Shows you the build number of software loaded in the Sensor.
First Detected At: Specifies the date and time when the system first detected the Sensor.
Busy in Troubleshooting?: Indicates whether the Sensor is currently busy capturing packets for
troubleshooting.
Sensor Mode: Specifies the mode of Sensor: Sensor, ND, or Sensor/AP Combo.
AP Mode: Indicates whether AP mode is enabled or disabled, that is whether the device is in AP mode or
not.
SSIDs configured: Specifies the SSIDs configured for the device in case AP mode is enabled. One or more
SSIDs will be seen here, depending on the number of SSIDs configured in the device template for this device.
To delete data for the selected Sensor and re-initialize data gathering, click .